Specifications
AGENCY LISTING INFORMATION
STD 4
E6070
INSTALLATION
NOTE: DO NOT discard
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
IMPORTANT:
This installation must comply
with all applicable Federal,
Local and NFPA codes.
UNPACkING & INSPECTION
Carefully remove the appliance from the carton. Remove all protective
before connecting electrical power or otherwise performing any
installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
place for later use.
COMPONENTS
1 ea. GREASE DRAWER (2 ea. for G-60)
1 ea. SCRAPER (for grooved griddle plates, if ordered)
1 ea. SPLASHGUARD
4 ea. ADJUSTABLE LEGS (6 ea. for G-60)
SETUP
Verify local codes for requirements. Concrete, tile, terrazzo or metal
surfaces are recommended. Metal over combustible material may not
meet code for non-combustible surfaces.
Install one adjustable leg at each corner of the griddle by screwing the
ON ALL
FOUR LEGS.
contact the counter in order to prevent tipping.
Refer to the Installation Instruction Sheet for required clearances.
Maintain required clearances between the appliance and adjacent
combustible surfaces.
appliance.
This appliance conforms to NSF Standard 4 for sanitation only if
installed in accordance with the supplied Installation Instructions and
maintained according to the instructions in this manual.
This appliance is U Listed under UL File E6070 for 120V, 208V and
240V.
4
Fig. 2 Adjustable Legs
101 p/n 2M-303339 OpManual Countertop Electric Griddles