WELLS MANUFACTURING COMPANY 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.
LIMITED WARRANTY STATEMENT Unless otherwise specified, all commercial cooking equipment manufactured by WELLS MFG. CO. is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only.
TABLE OF CONTENTS WARRANTY SPECIFICATIONS FEATURES & OPERATING CONTROLS PRECAUTIONS & GENERAL INFORMATION AGENCY LISTING INFORMATION INSTALLATION OPERATION CLEANING INSTRUCTIONS TROUBLESHOOTING SUGGESTIONS MAINTENANCE INSTRUCTIONS PARTS & SERVICE CUSTOMER SERVICE DATA xi 1 2 3 3 4 5 7 9 10 12 13 INTRODUCTION Thank You for purchasing this Wells Manufacturing Co. appliance.
FEATURES & OPERATING CONTROLS W LO A. THERMOSTAT MED IU M Soup Cooker and Cook ’N Hold Warmers are thermostatically controlled. Power is applied to the heating element according to the control knob position and the actual temperature at the sensing element. 2. The desired temperature is controlled by rotating the TEMPERATURE CONTROL KNOB. The knob may have a printed “arrow” which points to specific functions (e.g. COOK, HOLD), or to a graphic scale where “wider” corresponds to higher temperature. 3.
PRECAUTIONS AND GENERAL INFORMATION This appliance is intended for use in commercial establishments only. Soup Cookers and Cook ‘N Hold Warmers are intended to bring pre-cooked, frozen food product to serving temperature for human consumption. No other use is recommended or authorized by the manufacturer or its agents. Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions.
INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. CAUTION FIRE HAZARD Avoid storing flammable or combustible materials in, on or near the appliance. UNPACKING & INSPECTION Carefully remove the appliance from the carton.
OPERATION WET OR DRY OPERATION for SOUP COOKERS CAUTION: 1. Carefully read the description of the Soup Cooker operation on the specification sheet. 2. a. Most Soup Cookers are designed for WET OR DRY operation. b. Soup Cookers may be used wet, or may be used dry. However Soup Cookers and Cook ‘N Hold Warmers may NOT be used wet-to-dry or dry-to-wet unless they have been allowed to cool to room temperature between the change in wet or dry operation. c.
OPERATION (continued) PREHEAT FOR COOK ‘N HOLD WARMER CAUTION: 1. Place desired pan(s) or inset(s) with appropriate adapter top on warmer. a. Insets are available as accessories in 2½ qt., 4qt., 7 qt., and 11 qt. sizes with lids and adapter tops. 2. Turn temperature control to HI or highest temperature setting. 3. Allow warmer to preheat for recommended time (see chart below), then set the control for the desired temperature. Be sure to keep the warmer covered during preheat and operation.
CLEANING INSTRUCTIONS CAUTION: DAILY CLEANING INSTRUCTIONS PREPARATIONS: Turn control knob(s) to OFF. Unplug the warmer. Allow warmer to cool before proceeding. Remove any insets, pans and/or adapter tops ( if used). Remove water from well if used for wet operation. FREQUENCY: Minimum - daily. TOOLS: Mild Detergent Solution: 10 Parts Warm Water to 4 Parts Vinegar Plastic Scouring Pad Clean Cloth or Sponge 1. Wipe entire unit down using a clean cloth or sponge and mild detergent. 2.
CLEANING INSTRUCTIONS (continued) WEEKLY CLEANING INSTRUCTIONS for LLCH-1220 & 6411 FIRST AID EYES: In case of contact, immediately flush with warm water for 15 minutes and consult a physician SKIN: Wash with soap and water INHALATION: Relocate to fresh air. INGESTION: If swallowed, drink plenty of water or milk and consult a physician PREPARATIONS: Remove any insets, pans and/or adapter tops ( if used). Drain or remove water from well if used for wet operation.
TROUBLE SHOOTING SUGGESTIONS SYMPTOM No power to warmer Warmer will not heat Warmer trips circuit breaker Warmer slow to heat POSSIBLE CAUSE SUGGESTED REMEDY Circuit breaker off or tripped Reset circuit breaker Unit not plugged in Make sure unit is plugged in to power receptacle Temperature control not set Set control to desired temperature Internal damage Contact you Authorized Wells Service Agency for repairs Wet insulation Verify flange-to counter seal is sound, or reseal with food-grade s
MAINTENANCE INSTRUCTIONS CARE OF ANODIZED ALUMINUM (LLSC-7 & LLSC-11) The well in your Wells Warmer or Soup Cooker is constructed of high quality anodized aluminum. As long as the anodized surface layer is intact, the equipment will not corrode. The anodized surface can be damaged by mechanical abrasion, hard water deposits and chlorine: 1. NEVER use steel wool, wire brushes or metal scrapers to clean the warmer. These will damages the anodized surface of the well.
MAINTENANCE INSTRUCTIONS (continued) CARE OF STAINLESS STEEL (6411 & LLCH-1220) Stainless steel is a marvelous material: strong, lustrous and low maintenance. With a minimum of care, it will normally retain its beauty and durability for the life of the equipment. In some applications, however, special care is required in order to maintain stainless steel’s special properties. External components, such as cabinets and control panels, are finished with a grain pattern.
PARTS & SERVICE Always use an inset. DO NOT place food directly into the warmer pan. DESCRIPTION PART NO. INSETS 2½ QT. ROUND INSET w/ lid 20773 4 QT. ROUND INSET w/ lid 20774 7 QT. ROUND INSET w/ lid 20587 11 QT. ROUND INSET w/ lid 20908 11 QT. ROUND INSET w/ hinged lid 21057 ADAPTER TOPS FOR LLSC-11 ONE 7 QT. INSET ADAPTER TOP 20175 ONE 4 QT. INSET ADAPTER TOP 20822 ADAPTER TOPS FOR LLCH-1220 ONE 7 QT. AND ONE 4 QT. INSET ADAPTER TOP 21618 TWO 7 QT. INSET ADAPTER TOP 21502 TWO 4 QT.
PARTS & SERVICE (continued) DESCRIPTION PART NO. ACCESSORIES 6 oz. SOUP LADLE 21764 LEGS FOR LLCH-1220 LEGS, 1/2” Plastic Adjustable, set of 4 50676 LEGS, 1” Plastic Adjustable, set of 4 21109 LEGS, 2” Plastic Adjustable, set of 4 20605 LEGS, 4” Plastic Adjustable, set of 4 20314 LEGS, 4” Nickel Plated Alloy, Adjustable, set of 4 20563 CLEANERS DELIME CLEANER (Case of 24 7 oz. packets) 22838 IMPORTANT: Use only factory authorized service parts and replacement filters.
Wells Manufacturing proudly supports CFESA Commercial Food Equipment Service Association WELLS MANUFACTURING COMPANY DIVISION OF CARRIER REFRIGERATION 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 www.wellsbloomfield.
