Instruction manual

3.
set AC volts monitor from Pin 3 (GND)
Pin
4 (Xl
4. (R336) 2.22:l:0.0lV AC.
5. Monitor from Pin 3
of the OUTPUT connector to Pin 1 IY).
6.
y
(R230) for 1.65±O.OlV AC.
7. Set the X·Y SIZE control to the maximum CAL position.
8. Again from Pin 3 to Pin 4.
9.
cal (R229) for 5.55±0.OlV AC.
10. Monitor Pin 1
1 L
for 4.17±O.OlV AC.
12. Select the Scale pattern.
13. Connect the Pin 3 (GND) and Pin 7 (R/Z) of the OUT·
PUT connector
14. the White Level pot (R128) to obtain 4.00V±O.05V for the
step on the staircase
15. the Black Level pot (R 127) to obtain 1.00V±O.05V for the
lowest the staircase.
16. interact) until the voltages are
17. Set front panel controls follows:
TEST MODE TRAKER
VARI·TRAKER MODE SELECT VOLTS
18. Apply 200mV DC plus of the VARI·TRAKER input
19. SOUND CAL
so that a slow ticking sound is emitted
by the VARI~TRAKER.
This completes
of
instrument.
-31-
SECTION X
PARTS
LIST
When parts be sure to
the Hickok part number
indicated in the DESCRIPTION
models. Also include the model
mum billing is $50.00. Orders
prepaid
if ''''t'ornn.::''>1
postage and handling.
DESCRIPTION
CONN
FIELD REPLACEABLE
CAP: decorator, molded .....
CABLE ASSEMBLY: extender
CABLE ASSEMBLY adapter "AU
CABLE ASSEMBLY: adapter
CABLE ASSEMBLY "C"
CABLE ASSEMBLY. adapter "0"
CASE: molded, top
CASE: molded, bottom
CASE: carrying. vinvt (CC·S)
CORD: line
KNOB: round .
KNOB: square
LEAD SET: banana plug to prod
NAMEPLATE. front panel, upper
NAMEPLATE' front panel, lower
NAMEPLATE front panel, upper
PANEL: front
PANEL: upper left
PANEL ASSEMBLY: side (includes
PANEL ASSEMBLY rear
-32-