System information

WellGate 3804 User Manual
S/W version:4fxo.115
Release version,:2.4
-------------------------------------------------------------------------------------------------
usr/config$ tone
Setup of call progress tones
Usage:
tone -toneX LowFreq HighFreq LowFreqLevel HighFreqLevel TOn1 TOff1 TOn2
TOff2
tone -print
Note:
toneX has the following possibility:
busy1 busy2 reorder1 reorder2 ringtone1 ringtone2 dialtone
Example:
tone -busy1 400 0 8 0 50 50 0 0
tone -dialtone 400 0 19 0 25 25 0 0
5.18 [support] command
This command provides some extra functions that might be needed by users.
-----------------------------------------------------------------------------------------------------
usr/config$ support
Special Voice function support manipulation
Usage:
support[-tunnel enable]
support -print
-t38 T.38(FAX) enabled/disabled.
-fstart Fast start enabled/disabled.
-tunnel H245 Tunneling enabled/disabled.
-h245fs H245 separate channel after faststart.
Example:
support -fstart 1
support -tunnel 0
support -h245fs 1
Parameter Usages:
-print print current setting in support command.
-t38to switch ON/OFF (1 = ON; 0 = OFF) T.38 function.T.38 function is for
FAX. If user will use FAX machines, please switch on T.38
function.
-fstart to switch ON/OFF (1 = ON; 0 = OFF) FastStart function. Fast Start
function can shorten the connection time if the opposite party
also support FastStart.
-tunnel to switch ON/OFF (1 = ON; 0 = OFF) H.245 tunneling function. If the
function is ON, WellGate 3804 will send H.245 (Call Control
messages) via H.225’s (Call Signal messages) link. The
function is effective only when both side support h245 tunnel.
-h245fs to set if open H.245 separate channel after fast start or not. (1 = ON;
0 = OFF)
Note:
1. it is not recommended to change the value in this command, only if users
38