System information

WellGate 3804 User Manual
S/W version:4fxo.115
Release version,:2.4
-alias h323 ID, a identification in h323 world for other parties’ recognition.
The field might be used as a key of authorization or accounting in
some VoIP application. It is recommended to assign a special
name, or it might conflict with other devices.
-multi Switch ON or OFF gatekeeper discovery function (1 = ON; 0 = OFF).
When it’s ON, WellGate 3804 will multicast for gatekeeper if
default gatekeeper is not presented.
-rtp to allocate RTP port range—NOT RECOMMENDED. This may be used
when RTP port range conflicts with Firewall policy.
-h245 to assign h.245 port number, NOT AVAILABLE for the moment.
-ttl to set timer for TTL(Time To Live). WellGate 3804 would send RRQ, with
keepAlive, to gatekeeper periodically according to TTL timer.
-gkfind gatekeeper finding port. Port number, which WellGate 3804 uses it to
discover a gatekeeper. Default value is 1718.
-gwtype to set WellGate 3804 register mode as terminal or gateway,0 as
terminal 1 as gateway. Please notice that if set WellGate 3804 as
terminal mode, must set sysconf –2nddial 1(refer to 5.12).
-rasto set default gatekeeper RAS port number. Default value, 1719, is well-
known port for RAS communication.
-range to allocate dynamic port range, which WellGate 3804 might be using.
-respto response timeout. Max waiting time for 1st response to a new call
(1~200).
-connto connection timeout. Max waiting time for call establishment after
receiving 1st response of a new call (1~20000).
5.14 [gk] command
This command is to configure embedded simple gatekeeper related
parameters. If user doesn’t have a gatekeeper or WellTech Call Manager,
WellGate 3804 provide a simple embedded gatekeeper for up to 10
endpoints.
------------------------------------------------------------------------------------------------
usr/config$ gk
Gatekeeper information and configuration
Usage:
gk [-add type1 [[type2]...]] [-delete h323] [-ttl value
[-enable 0/1] [-security enable/disable]
-print Display the enabled debug flags.
-enable Enable simple gatekeeper
-ttl Set TTL value
-add Add dynamic endpoint
(h323 ID, E164, IP, port, type)
-delete Delete dynamic endpoint
-security enable Enable security check
-security disable Disable security check
-security add Add security record
-security delete Delete security record
Example:
gk -add h323 256 192.168.1.1 1720 0
gk -delete h323
gk -security delete h323
34