System information

WellGate 3804 User Manual
S/W version:4fxo.115
Release version,:2.4
respectively. Every channel uses a different pincode.
-ring: To set when dial in WellGate 3804 from PSTN side, WellGate 3804 will
pick the call immediately or rings for specific times before picks up.
0  disable: pick up immediately
1-5  times of ring before WellGate 3804 picks up.
- callalive: Call Alive function (1 = ON; 0 = OFF). The function is used to check
if the opposite party is alive when connection is established. When
CallAlive is activated, WellGate 3804 will send H.245
RoundTripDelay message to other party, and wait for response. If the
other party cannot respond the message in 10 seconds, WellGate
3804 will regard the opposite party as IDLE state and disconnect the
call. When CallAlive is deactivated, RoundTripDelay message will not
be sent during connection.
- keypad: keypad type when relay DTMF signal.
0  In-Band
1  h.245 alphanumeric
2  h.245 signal type
3  q.931 user info
- pincode: to specify 2 sets of pincode.
-sendxcode: send access code after connection (1 = ON; 0 = OFF)
-access: specify access codes (per port basis) .
Note:
1. This feature can only implement with LineToLine service. Please refer
to –service above.
2. This function can help users to restrict callers to dial particular
numbers from IP side to PSTN side. For example, if user set sysconf
–access set1 1111, when callers call from IP side and enter WellGate
3804 port 1, if user dial 234 after hearing dial tone, WellGate will dial
out 1111234.
-------------------------------------------------------------------------------------------------
usr/config$ sysconf –sendxcode 1 –access set1 1111
5.13 [h323] command
This command is to configure H.323 related parameters.
------------------------------------------------------------------------------------------------
usr/config$ h323
H.323 stack information and configuration
Usage:
h323
h323 [-gk ipaddress] [-multicast used] [-e164 number] [-alias h323id]
[-rtp port] [-h245 port] [-ttl time] [-gkfind port] [-ras port]
[-range [start num1] [end num2]]
h323 -print
-print Display H.323 stack information and configuration.
-mode Configure as Gatekeeper mode or Peer-to-Peer mode.
-gk Gatekeeper ip address. (0.0.0.0 ~ 255.255.255.255)
-dfgw Default Gateway ip address. (0.0.0.0 ~ 255.255.255.255)
32