System information

WellGate 3804 User Manual

applied to ITSP, who provides international VoIP solution.

Note: In LineToLine service, must set WellGate 3804 sysconf –

2nddial 1 .

- ringdet: to define ring detection method. (0 is for old hardware version; 1 for

new hardware version)

- plan: It is for setting dial-numbering plan. While e164 number is three digits,

the plan should be set as 3 or 0. The plan 0 is for any positive digits

use.

- port: This command can enable or disable individual port. The default value

is set to enable all ports.

- seizure: line seizure mode.

None (0)  when calling from IP side, choose L1 every time if it is

available.

UCD (1)  when calls from IP side, choose L1 for the first time, and L2

for the 2

time, (cyclic)

Note: Do not enable this function together with group (please refer to 5.18).

- 2nddial: This command is necessary for setting one time dial method use.

While user would like to skip 2nddial process, WellGate 3804 must

close 2nddial and set as 0 (2nddial off). The default value is set as 1

(2nddial on).

- drule: This command only works while 2nddial is off. When user would like to

make an outgoing call or receive an incoming call shortly, it is

necessary to set the following three commands belonged to drule.

●drop: drop the dial digit.

●insert: insert the dial digit

●filter: filter the dial digit.

Note:

1. out: Through WellGate 3804 to dial out to another Gateway’s e164

number. When making an outgoing call, it is necessary to set three

commands in order, filter, insert then drop.

Example: sysconf –drule out_filter 002886 out_insert 0 out_drop 02

2. in: Through pass WellGate 3804 in order to connect with PSTN / PBX

side. When making an incoming call from other Gateway, the three

commands is necessary to be set in order, drop, insert, then filter.

Example: sysconf –drule in_drop 002886 in_insert 0 in_filter 02

3. 3. While the specified digit would like to be deleted, use the character x

instead of any digits have configured.

-askpin:

0  disables ASKPIN function

1  enables ASKPIN function, and apply to the whole unit. Every

channel uses the same PINCODE.

2.  enables ASKPIN function, and apply to each channel