System information

WellGate 3804 User Manual
S/W version:4fxo.115
Release version,:2.4
from IP side needs to dial GW's E164, wait for PSTN
dialtone, and then dial out.
-drule Specify digits to be filtered/dropped/inserted before
making an outgoing IP call or after receving an incoming
IP call.
-askpin PIN code prompt before greeting.
0:Disable 1:Per Unit 2:Per Channel.
-ring Ring number before answer.
0:Disable, other is number of ring ( 1 ~ 5 ).
-callalive Enable or disable auto-disconnection after 10 seconds
-keypad DTMF setting: 0=In-band, 1=H.245 Alphanumeric,
2=H.245 SignalType, 3=Q.931 UserInfo.
-pincode Specify 6 sets of PIN codes.
-sendxcode Send access code after connection.
0:Disable 1:Enable.
-access Specify access codes.
Note:
Use character 'x' to delete the drule parameter.
For line seizure 0: None, 1: UCD.
For askpin: f=0: No, f=1: Yes.
Hotline feature should be used together with:
$sysconf -2nddial 0 (2nddial off)
$h323 -mode 1 (peer-to-peer mode)
$bureau -print for Hotline/LineToLine table configuration.
LineToLine feature should be used together with:
$sysconf -2nddial 1 (2nddial on)
$h323 -mode 1 (peer-to-peer mode)
$bureau -print for Hotline/LineToLine table configuration.
Example:
sysconf -service 0 -plan 4 -port 1 1 1 1 0 0
sysconf -callalive 0 -keypad 0
sysconf -2nddial 0 -drule out_filter 002 in_insert x in_drop 1
sysconf -askpin 1 -pincode set1 12345
sysconf -sendxcode 1 -access set1 12345#
- service:
0  Dial In Service
in Dial In Service, Wellate3804 will pick up incoming calls from
PSTN, play pre-recorded voice greeting or, and then have users to
make a 2
nd
dial to destination.
2  HotLine/ LineToLine Service (this feature must be implemented in
a pair of FXO products in P2P mode and set bureau –table
command)
HotLine Service provides Hot Line function, which connects directly
to pre-defined destination. For ex: if L1 of WellGate 3804 is assigned
to destination address 192.168.1.12 in Hot Line Mode. When users
from PSTN make a call to L1 of WellGate 3804, it will directly
connect to 192.168.1.12 without a 2
nd
dial.
Note: In hotline service, must set WellGate 3804 sysconf –2nddial 0 .
LineToLine Service is like HotLine Service, but ask for a specific line
number. For ex: if L1 of WellGate 3804 is assigned to destination
address 192.168.1.12 /Line4 in LineToLine Mode. When users from
PSTN make a call to L1 of WellGate 3804, it will directly connect to
192.168.1.12 and choose Line4 to call out to PSTN. This is mostly
30