System information

WellGate 3804 User Manual
Index Name IP E164
1 B_gateway 192.168.1.2 0
-------------------------------------------------------------------------------------------
B  E1 trunk gateway, which connects to PSTN with E1 PRI.
If users want to make a call to PSTN number “82265699”, they have to pickup one of
the phone connected to WellGate 3804, and then dial “082265699”. After receiving
the complete dialed number, WellGate 3804 will search for its Phone Book, find “0”
as matched prefix, and then dial out to B’s IP address directly with destination e.164
(phone number) “82265699”. Pleased be noted that “0” is eliminated from WellGate
3804 itself.
Note:1. Because of above characteristics, users have to take care of the number plan
very well to avoid the numbering conflict. If users already defined “0” for
specific trunk gateway, other terminal started with “0” shall be avoided, or the
number will be routed to the trunk gateway defined “0”.
2. If user wants to set 2 sets of similar e164 such as 123 and 1234, please be
careful configure 123 first, or it may cause problem when user dial 1234,
WellGate 3804 may dials out IP address of 123.
3.
(1) If called party is FXO product, please set e164 of pbook as e.164 of called
party, and remember to set sysconf –drule in_drop “e.164”(refer to 5.12.)in
called party.
(2) If called party is FXS product, please set e164 of pbook as prefix of called
party, when dialing to different line of FXS product, please dial line number.
5.12 [sysconf] command
This command displays the system information and configuration.
-------------------------------------------------------------------------------------------------
usr/config$ sysconf
System information and configuration
Usage:
sysconf [-service type] [-plan digits] [-2nddial flag]
[-keypad dtmf] [-ringdet method] [-callalive flag]
[-port s1 s2 s3 s4 ]
[-seizure mode] [-2nddial switch]
[-drule [in_filter str1] [in_drop str2] [in_insert str3]
[out_filter str4] [out_drop str5] [out_insert str6]]
[-askpin f] [-pincode [set1 pin1] [set2 pin2] [set3 pin3] [set4 pin4]]
sysconf -print
-print Display system overall information and configuration.
-service Specify gateway service type.
(0: Dial in service,2: HotLine/LineToLine service.)
-ringdet Specify gateway ring detect method. (0:For 1st hardware version,
1:For 2st hardware version.
-plan Number of digits for dial plan. (any positive
number.)
-port Enable/Disable individual port.
-seizure Choose line seizure mode (None/UCD).
-2nddial Config GW to accept 2nd dtmf set. In this mode, device
29