System information

WellGate 3804 User Manual
Parameters Usage:
-status Display the enabled debug flags.
-add Add debug flag.
-- h323 : h323 related information
-- vp : voice related information
-delete Remove specified debug flag.
-open Start to show debug messages.
-close Stop showing debug messages.
5.4 [reboot] command
After commit command, type reboot to reload WellGate 3804 in new configuration.
The procedure is as below:
usr/config$ reboot
Attached TCP/IP interface to cpm unit 0
Attaching interface lo0...done
AC4804[0] is OK
AC4804[1] is OK
AC4804[2] is OK
Successful
Initialize OSS libraries...OK!
open stack successful
cmInitialize succeed!
GK mode selected.
login:
5.5 [flash] command
This command will clean the configuration stored in the flash rom and reboot
WellGate 3804 in factory default setting.
Parameter Usage:
-clean clean all the user-defined value, and reboot WellGate 3804 in factory
default mode.
Note: It is recommended that use “flash –clean” after application firmware id
upgraded.
Warning: Once users execute flash –clean, all the configurations of
WellGate 3804 will be cleaned. This can only be executed by user who log
in with root
5.6 [commit] command
23