System information

WellGate 3804 User Manual
S/W version:4fxo.115
Release version,:2.4
3.2 Peer-to-Peer Mode
Peer-to-Peer Mode allows users to call other VoIP devices without using a
gatekeeper. When in Peer-To-Peer mode, WellGate 3804 will send SETUP
message directly to the destination IP address once the dial is finished. Users
have 2 methods of dial. One is IP dialing, and the other is Phonebook dial, which
we will describe later. When using IP address as destination phone number, press
“*” as “.” in IP address expression, and press “#” when dial is finished. When using
Phonebook, users can dial predefined phone number, and press “#” (optional, to
accelerate the dial) as end of dial. Or, users can use SpeedDial button, which is
mapping to user defined Phonebook, Button1 to PhonebookIndex1, Button2 to
Phonebook Index2,…etc.
To configure Peer-To-Peer Mode in WellGate 3804, follow the steps below:
1. Set Peer-To-Peer Mode, using “h323” command
-------------------------------------------------------------------------------------------------
usr/config$ h323 –mode 1
Note: mode 1 is for Peer-To-Peer (non-gk) mode, while mode 0 is for GK
mode.
2. Configure Phonebook, using “pbook” command.
Users can refer to chapter 5.11 [pbook] command for more information.
-------------------------------------------------------------------------------------------------
usr/config$ pbook –add name TEST1 ip 10.1.1.1 e164 10
Note: the command is to add a record onto Phonebook. After the command
completed, you can type “pbook –print” to see if the input record is correct.
When adding a record to Phonebook, users do not have to reboot the
machine, and the record will be effective immediately.
16