User manual

26xx Technical Manual EN-V108

than the Flash high setting, the flash

will be handled as hang-up.

Secondary Ringing (FXS only)

Note: The feature will be enabled automatically when the Min. Digit

Count has been enabled and specified. It is used to have different ring

cadence when the incoming caller number is shorter than the setting of

“Min. Digit Count”

Ringing Frequency Specify the Ringing frequency value.

ringing frequency : 15~100 (Unit : Hz)

Ringing ON Specify the Ringing ON value.

ringing ring ON : 0~8000 (Unit : ms)

Ringing OFF Specify the Ringing OFF value.

ringing ring OFF : 0~8000 (Unit : ms)

Ringing level Specify the ringing level.

ringing level : 0 ~ 94 (Unit : V)

Min. Digit Count Specify the minimum digit count

(1~10, 0: Disable), this feature is used

to change the ringing frequency by

detecting the digit length of incoming

calls’ number. When the digit length

of an incoming caller number is greater

than the specified setting, the system

will use primary ringing. If the digit is

less than the specified setting, the

system will use the secondary ringing.

Country Specify the ringing standard to use.

1. Press the “Apply” button (at the bottom) after you finish to save changes.

2. Press the “Reboot” button to apply the changes.