SDS

WSW SAC L0 / WSW SAC M1 - Solder Wire lead free Sn3.0Ag0.5Cu Flux L0/M1
Safety Data Sheet
According To Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules And Regulations And According To The Hazardous Products Regulation (February 11, 2015).
09/15/2021
EN (English US)
6/9
Respiratory Protection: If exposure limits are exceeded or irritation is experienced, approved respiratory protection should be worn.
In case of inadequate ventilation, oxygen deficient atmosphere, or where exposure levels are not known wear approved respiratory
protection.
Thermal Hazard Protection: If material is hot, wear thermally resistant protective gloves.
Environmental Exposure Controls: Avoid unnecessary release into the environment.
Consumer Exposure Controls: Wear recommended personal protective equipment.
Other Information: When using, do not eat, drink or smoke.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
9.1. Information on Basic Physical and Chemical Properties
Physical State
:
Solid
Appearance
:
Silver
Odor
:
Wire
Odor Threshold
:
Not available
pH
:
Not available
Evaporation Rate
:
Not available
Melting Point
:
217 – 221 °C (422.6 – 429.8 °F)
Freezing Point
:
Not available
Boiling Point
:
Not available
Flash Point
:
Not available
Auto-ignition Temperature
:
Not available
Decomposition Temperature
:
Not available
Flammability (solid, gas)
:
Not available
Lower Flammable Limit
:
Not available
Upper Flammable Limit
:
Not available
Vapor Pressure
:
< 0.1 mbar [@ 20 °C (68 °F)]
Relative Vapor Density at 20°C
:
6 [@ 20 °C (68 °F)]
Relative Density
:
7.4 [@ 20 °C (68 °F)]
Specific Gravity
:
Not available
Solubility
:
Insoluble in water.
Partition Coefficient: N-Octanol/Water
:
Not available
Viscosity
:
Not available
SECTION 10: STABILITY AND REACTIVITY
10.1. Reactivity: Hazardous reactions will not occur under normal conditions. May form explosive hydrogen gas on contact with
acids.
10.2. Chemical Stability: Stable under recommended handling and storage conditions (see section 7).
10.3. Possibility of Hazardous Reactions: Hazardous polymerization will not occur.
10.4. Conditions to Avoid: Direct sunlight, extremely high or low temperatures, and incompatible materials.
10.5. Incompatible Materials: Strong acids, strong bases, strong oxidizers.
10.6. Hazardous Decomposition Products: Thermal decomposition may produce: Metallic oxides. Carbon oxides (CO, CO
2
).
SECTION 11: TOXICOLOGICAL INFORMATION
11.1. Information on Toxicological Effects - Product
LD50 and LC50 Data: Not available
Skin Corrosion/Irritation: Not classified (Based on available data, the classification criteria are not met)
Eye Damage/Irritation: Not classified (Based on available data, the classification criteria are not met)
Respiratory or Skin Sensitization: May cause an allergy or asthma symptoms or breathing difficulties if inhaled. May cause an allergic
skin reaction. Evidence of both skin and respiratory sensitivity has been observed in both humans and laboratory animals.
Acute Toxicity (Oral): Not classified (Based on available data, the classification criteria are not met)
Acute Toxicity (Dermal): Not classified (Based on available data, the classification criteria are not met)
Acute Toxicity (Inhalation): Not classified (Based on available data, the classification criteria are not met)