Datasheet

To reduce the risk of injury or property damage, READ AND UNDERSTAND the following
warnings.
1. Do not fill gas or store near open flame, heater, furnace or combustible materials.
2. Use only non-aromatic butane gas as recommended by the manufacturer.
3. Be sure to put switch down after use.
4. Use only in open air place or well ventilated place.
5. Avoid dropping or causing a hard shock.
6. Do not use iron holder designed for the electrical iron. This may cause burning of
tool body.
7. Do not store under direct sunlight or anywhere that will exceed 40°C or 140°F. This
will cause fire / explosion as gas pressure become high.
8. Do not store near windshield, in trunk of car.
9. Keep out of reach of infants.
10. Keep hands and combustibles clear out of exhaust opening and tip housing to avoid
burns or fire.
11. Do not immerse in water.
12. Do not try to disassemble or misuse or alter or tamper.
13. Cool down before putting protective cap on.
Specifications
Lenght incl. soldering tip 242 mm (soldering and hot blow)
198 mm (torch)
Weight incl. gas filling 105 g (soldering and hot blow)
95 g (torch)
Temperature values About 200°C-500°C Soldering tip end
About 700°C max. at hot blow tip end
About 1.300°C max. at torch (burner)
Burning time per gas filing About 11/2 - 4 hours
(soldering and hot blow)
About 50 minutes at max. gas flow (torch)
Te environmental temperature will slightly
influence the burning time
Filling quantity Max. 15 g
IMPORTANT SAFETY INSTRUCTIONS
SPECIFICATIONS
Soldering tip or
hot blow tip
Housing for sol-
dering tip or for
hot blow tip
Torch ejector
Ignition vent
OPEN/CLOSE knob
Control lever position 1 o 5 for adjusting
gas flow and so tip temperature and lame
lenght when tool is used as a torch
Gas-level window
LP Gas Refill
Nozzle
Hot air exhaust
hole *CAUTION:
Keep clear as
hot air comes
out here
Kurled screw
Soldering
ejector
Spanner
Gas OPEN/CLOSE
main lever
Handle containing
butane gas
14