Installation guide



Wellav Technologies Ltd.
24
SMP260 Quick Installation Guide
V1.10-W
Pic-3.3-40
Parameters Description
ChannelSelect
In this ‘ChannelSelect’, user can select a channel to
configure its transmitting parameters.
Enable
On: enable the IP transmission function.
Off: disable the IP transmission function.
Note: this parameter setting applies to all channels.
Channel configuration
EnableChannel Enable or disable corresponding output channel
SourcePort Set port of multicast/unicast
DestIPAddress Set IP address of the multicast/unicast.
Protocol Select UDP/RTP for multicast/unicast
EncapNumTSPackets Rang 1~7. (Num 7 is recommended)
TSPacketSize Select 188/204 TS packet size
TypeofService
Select one service type as your requirement. Type
including: Normal, Min delay, Monetary cost, Max
reliability, Max Throughput.
Bitrate Parameter
Mode Mode includes: CBR/VBR