Installation guide



Wellav Technologies Ltd.
23
SMP260 Quick Installation Guide
V1.10-W
Parameters Description
ChannelSelect
In this ‘ChannelSelect’, user can select a channel to configure its
parameters.
Enable
On: enable the IP receiving function.
Off: disable the IP receiving function.
Note: this parameter setting applies to all channels.
Channel configuration
EnableChannel Enable or disable corresponding input channel
SourceIPAddress
Set the IP address of the multicast/unicast that are going to
receive
SourcePort Set port of multicast/unicast
Protocol Select UDP/RTP for multicast/unicast
ColPortMatching If the output IP stream quality looks not as good as the input
stream, user can select to ‘Enable’ these two options then to
enable the FEC function.
RowPortMatching
FEC Parameter
The bigger values it is, the stronger capabilities it has to correct
the data mistakes. But the FECL and FECD should be less than
100.
z Configure parameters of signal output modules
z ASI OUT
The ASI output parament configuraion is introduced in page22.
z IP OUT
IP module-Output
The “Output” setting menu is to set the IP output function for transmitting multicast/unicast
IP stream.