Installation guide



Wellav Technologies Ltd.
15
SMP260 Quick Installation Guide
V1.10-W
z Exit Menu/Back to parent Menu
 Upon completion of configuration settings, press “MENU
” button until you go back
to the Parent Menu.
 You can also go back to Parent Menu directly by pressing “ESC
” button once.
z Enter Sub-Menu
 Press MENU
button to enter main menu.
 Select a sub-menu by pressing arrow UP
and arrow DOWN button.
 Press OK button on the selected sub-menu.
z To change parameter
 Step 1: Enter main menu by pressing MENU
button.
 Step 2: Scroll sub-menu by pressing arrow UP
and arrow DOWN button, and press
OK
button to change the selected sub-menu.
 Step 3: To change parameter settings, press arrow RIGHT
and arrow LEFT button
to move the cursor in which change must be made.
 Press arrow UP
button and arrow DOWN to input / select an appropriate setting,
then press OK
button to save.
6.2.2 Check Out and Change the Default IP Address
z Step 1: check out the IP on the LCD screen.
z Step 2: use the button on the front panel to change the IP, gateway and subnet mask.
The gateway should be the same as the management PC’s. The subnet mask should
be the same as the management PC’s s. The IP and the server’s IP should be in the
same section.
z Step 3: reboot the device to take effect.
z Step 4: ping the new IP on PC to check whether the SMP260 can connect to the
management PC.
6.2.3 Configuration through NMS
Accessing the equipment through NMS can be very convenient for remote
configuration of the equipment. Relative to the front panel settings, NMS operation
can provide a more user-friendly man-machine interface, and less limits in space. For