Installation guide

17
Connecting an external amplifier/active subwoofer to your
system
Should extra amplification power, or, an active subwoofer be required, a
line level pre-amp output is provided on the back of the WCU300.
Using high-quality audio interconnect cable, an external power amplifier
may be connected to the WCU300 pre-amp output screw terminals.
A fader function on the WCU300 can be used to adjust the level between
the speakers connected to the WCU300 and the external amplifier/active
subwoofer, so that the balance between the two can be adjusted.
CCTV
A CCTV system may be connected to the Opus 300 Multi-Room system.
Connect the monitor/TV video signal output to the VSU300 at the CCTV IN
socket located on the top surface of the unit allowing the live video feed to
be viewed in all connected zones.
If sound is also required, the audio signal output of the CCTV system may
be connected to the EXT/CCTV inputs on the MCU300.
If the CCTV system is to be remote controlled connect an IR-1 infra-red
emitter to the ALL COMMANDS output on the MCU300 and stick the
emitter over the IR receiver of the CCTV system. This will allow the user to
control the CCTV system from any room in the house.
Active subwoofer or
external amplifier
Twin
screened
cable
Outlet with two
Phono/RCA sockets
CCTV hub
Video
Cat-5 cable
Audio
(if available)
IR-1
OS165CC
MCU300
WCU300
MCU300 VSU300