User guide

User Guide W52P IP DECT Phone
44
To trigger the auto provisioning:
1. Press to enter the main menu.
2. Select ->System Settings->Auto Provision.
3. Enter the system PIN (default: 0000) and press the Done soft key.
4. Enter the valid value in the Username field and press the OK soft key.
5. Enter the valid value in the Password field and press the OK soft key.
The LCD screen prompts the warning “Update now?”.
6. Press the Yes soft key to perform an update or press the No soft key to cancel.
Eco Mode+
Eco Mode+Eco Mode+
Eco Mode+
Eco mode+ turns off the transmission power and the radio waves emitted are
virtually zero when the phone is in the standby mode. If the eco mode+ is
enabled, the base station only transmits a signal when necessary, for example,
when a call comes in, when the phone is in use, or when a connection occurs.
To configure the eco mode+:
1. Press to enter the main menu.
2. Select ->System Settings->Eco Mode+.
3. Press the Change soft key to check or uncheck the Eco Mode+ checkbox.
4. Enter the system PIN (default: 0000) and press the Done soft key.
The LCD screen prompts the warning “Are you sure you want to reboot the base
station?”.
5. Press the Yes soft key to reboot the handset.
The base station reboots to make the configuration take effect. The configuration
applies to all the handsets registered to the same base station.
Eco Mode
Eco ModeEco Mode
Eco Mode
Eco mode greatly reduces the transmission power and signal output no matter
the phone is in standby mode or talk mode.
Eco mode is disabled by default and the color of the signal strength indicator
shown on the top left-hand corner of the idle screen is white.
To configure the eco mode:
1. Press to enter the main menu.
2. Select ->System Settings->Eco Mode.
3. Press the Change soft key to check or uncheck the Eco Mode checkbox.