User guide

User Guide W52P IP DECT Phone
18
Locking/Unlocking
Locking/Unlocking Locking/Unlocking
Locking/Unlocking Keypad
KeypadKeypad
Keypad
You can lock the handset keypad to prevent keys from being accidentally pressed.
To lock the keypad:
2. Long press when the handset is idle until the LCD screen prompts the message
“Keypad Locked, Press and hold ‘#’ to unlock!”.
The keypad is locked and the icon appears on the idle screen.
You can still answer or reject incoming calls as usual. You can also end the
answered call by pressing .
To unlock the keypad:
2. Long press again until the LCD screen prompts the message “Keypad
Unlocked”.
The keypad is unlocked and the icon disappears from the idle screen.
Note
Locating a
Locating a Locating a
Locating a Handset
HandsetHandset
Handset
You can locate a misplaced handset using the base station to which this handset is
registered.
To locate a handset:
2. Press on the base station.
All handsets registered to this base station will ring simultaneously (Paging) and
display the IP address of the base station on the LCD screen.
This helps you locate your handset easily.
You can press any key on the handset or press again on the base station to
end paging.
Switching
Switching Switching
Switching S
SS
Si
ii
il
ll
lent Mode
ent Modeent Mode
ent Mode On/Off
On/OffOn/Off
On/Off
If the silent mode is switched on, the handset will not ring when receiving an incoming
call, but you can still see the incoming call information on the LCD screen. You can
switch the silent mode on if you do not want to be disturbed.
If the keypad is locked, only the emergency numbers can be dialed out. You must enter
the digits of the emergency number continuously. To make emergency calls, you should
configure the emergency numbers in advance. For more information, refer to
Emergency Numbers on page 40.