User manual

mPBX-100 User Manual
www.yeastar.com Page 51
Users may transfer an incoming call by dialing *3 on their phone (*3 is default
setting).
·Blind Transfer
Users may blind transfer an incoming call by dialing *03 on their phone (*03 is
default setting).
·Call Pickup
Users may pick up an incoming call by dialing *4 on their phone (*4 is default
setting)
·Extension Pickup
Users may pick up a specific extension’s incoming call by dialing *04+extension
number on their phone (*04 is default setting)
·Intercom
Define the feature code that is used to dial an extension in intercom mode. For
instance setting this value to *5 would allow you to initiate an intercom call with
extension 501 by dialing *5501.
2) Call Park Preferences
·Call Parking
User may park an incoming call on his own telephone by pressing ‘*6’ (*6 is
default setting)
·Extension range used to park calls
User may park an incoming call on a designated extension at first and then pick
up the call again on any other extension.
·Number of seconds a call can be parked before it is recalled.
Defines the number of seconds that a call can be parked before it is recalled to
the station that parked it .
3) Call Forwarding Preferences
·Reset to Defaults
Users may reset all call forward defaults by calling *70 on their phone (*70 is
default setting).
Note: When reset to defaults. The call forwarding settings will be configured as
follows:
Always forward: Disabled
Busy forward to Voicemail: Enabled
No answer forward to Voicemail: Enabled
Do not disturb: Disabled