Bushmen AT RS CHARGER INVERT THE BULLET INTO THE JACK | fi'flfisfi NAME OF EACH PART REAR SIGHT E Fee REAR SLING HOOK FRONT SIGHT 5 5 M3 FRONT SLING HOOK AIR TAIL STOCK LOCK LEVER i /B 34 Brit EH FRONT CAR Hi% 6B Cle MUZZLE "SELECTOR TRIGGER | SAFETY HE\ER TRIGGER MOUNT SUPPORT EJECTION PORT FORE GRIP Al 18 COCKING LEVER M STOCK BAR side MOUNT RAIL member BOLT CATCH RELEASE TAIL STOCK MAGAZINE RELEASE LEVER RELEASE BUTTON Re Red IR E MAGAZINE e WRENCH L
SELECTOR L NEVER OPERATE THE SELECTOR WHILE PULLING THE TRIGGER. OTHERWISE, MALFUNCTIONS MAY OCCUR. PULLING THE TRIGGER WITH THE SELECTOR BEING SET 10O SAFE MAY DAMAGE THE GUN. WA E ML SHRINER 8 /E ZIR R G RE= BRI E SRR K A cg VNS4S PULL UPWARDS UNTIL SAFETY GITE Sel THE SELECTOR 10 THE SAFE POSITION WHILE YOU ARE NOT USING 1T EE ELDERBERRY ETHEL SINGLE SHOT ONE BULLET ONE TIME. My ma Running SHOT MORE BULLET ONE TIME.
BRIEFING B INSTALL\DISASSEMBLE THE MAGAZINE 1 TURN THE SELECTOR TO THE SAFE POSITION, BB/ SENSELESS 2 UE o 2 PRESS THE MUZZLE RELEASE BUTTON WHICH IS UNDER THE MUZZLE TO PULL OUT THE GUN HEAD. 2 T 0BT 840 IR B R H3R T iR ok THE MUZZLE RELEASE BUTTON 3 INSTALL THE BUTTERY INTO THE GUN 4 AIM AT THE CHAMBER AND INSTALL AS ILLUSTRATION. THE GUN HEAD.
ELEVATION ADJUSTMENT TURNING THE ELEVATION ADJUSTMENT SCREW WILL MOVE THE BULLET HITTING POINT TO THE UPPER LOWER. TURN ANTI-CLOCKWISE: LOWER THE BULLET HITTING POINT. TURN CLOCKWISE :RAISE THE BULLET HITTING POINT. WIND AGE ADJUSTMENT TURNING THE WIND AGE ADJUSTMENT DIAL WILL MOVE THE BULLET HITTING POINT 10 THE LEFT OR RIGHT TURN ANTI-CLOCKWISE: THE BULLET HITTING POINT TO THE LEFT. TURN CLOCKWISE: THE BULLET HITTING POINT TQ THE RIGHT. SEAT METATHESES BID ROADRUNNER (KA.
7 MITZI# COCKING LEVER COCKING LEVER AN HOP UP ADJUSTMENT DIAL i flmillflfim s § PRESS THE COCKING LEVER AND PULL 1T OUT BAFFLE CEW BRI E. R BOLT CATCH RELEASE PULL THE COCKING LEVER TO PULL THE BAFFLE RIGHT AND LEFT, THE HOP UP ADJUSTMENT DIAL IN THE EJECTION PORT EXPOSED AND RUNNING. THE BOLT CATCH RELEASE MOVES. WA B HERE BARHOP Uptight it 8 EILEEN THE OPERATION OF REAR GUN STOCK THE STOCK |___LOCK LEVER B xat S ’ THE RESEAL LEVER FOR T PUSH THE LEVER 10O REAR GUNS] RELEASE THE REAR GUN STOCK.
ADJUSTMENT PROCEDURE KEEP PULLING THE COCKING LEVER WHILE ADJUSTING THE DIAL IF TURN THE HOP ADJUSTMENT DIAL LITTLE BY LITTLE TO THE LEFT, HOP WILL START. (THE POSITION TO WHICH BB BULLET FLIES HORIZONTALLY IS THE BEST) TURNING THE DIAL EXCESSIVELY WILL ADVERSELY AFFECTS THE TRAJECTORY OF THE BULLET. WT REF SR NSE U HOPPER GOBS KRF A M HOP ADJUSTMENT DIAL THE BEST POSITION IS WHERE THE BULLETS FLY HORIZONTALLY, AND THE LONGEST FLYING DISTANCE IS OBTAINED SEE I SUFFRAGETTE @z\ i S WHEN ABOUT ROUNDS ARE FIRED
10 {535 CLEANNESS 1 MAINTENANCE WHEN BULLET SPEED BECOMES LOW DROP A FEW DROPS OF SILICONE OIL OR TEFLON OIL INTO THE BULLET ENTRANCE. AFTER THE CLEANING, USE THE CLEANING ROD (WITH COTTON) . TO REMOVE EXCESS OlL.
