Owner`s manual

five
Meijer.com
OPERATING INSTRUCTIONS
The manual controls are located on the left side of the fireplace.
You nave tl'le following controls:
OPERATING BY REMOTE CONTROL
11 Plug in your electric fireplace.
2J Make sure the unit's Main Power ON/OFF
Switch is at the ON position! The remote
control will NOT work if the Main Power
Switch is at the OFF position.
31 When operating the remote control, it
must be pointed towards the front of the
unit.
4/ The ON/OFF button at the below right of the
remote is the main ON/OFF power button
(Figure
5). Pressing this button activates
the power
to the unit. I
51 To activate the heater, press the I
button. Press and release the
button to cycle through LO, HI and
OFF.
6/ To adjust the flame height and ember bed
brightness, press the ~ b ~ or
.. t) • buttons. To increase the flame
height sIJd ember bed brightness, press
the" 0 "button, to decrease the
flame he1ght and ember bed brightness,
press the" 0 • button. There are
levels of (iame af feets.
71 To tum off the fireplace, press the
ON/OFF button once. NOTICE: This
remote control must remain within 8
meters or 26
feet of the fireplace to be
effective.
1. PowerONlOFF: Powertotheunit
2. Flame brightness controls: Allows you to adjust
the lIame
to suit your mood. Press /) to Increase
lIame brightness and
b to dec~ flillme
brightness. You must P~ the 9 button several
times to see the
full flame effect
3. Lowheat 700watts
4. High heat 1400watts
P lease note: The heater touchpilld control must be
touched
2 times toachleve hIgh heat.
s. HNterTlmer: Allows yoo to II!iIYe yoor hem!r
on whlleyoo sleep
with In lutornatk:lImerfor shut
off. You an Htyaur hl!ltl!rto be on for 1/2 hour
Increments
mrdng M. 1/2 hour up to. maximum
of 7-1/2 hours - press ono:efor eI!Ich 1/2 hour
Increment.
A~r yau IeICh 7·112 hoI.n 1he next
press will shut offtlM= feltu~
Note: Make sure your
batteries are fully
charged and Installed
correctly In your remoiB
control.
Figure 5
Remote Control For
Electric Fireplace