User manual

Well SEC Electronic Co., Ltd Http://www.wellsecurityalarm.com
Page １５ of 35 Ver 2.1
remote controllers.
LCD display:
4
6.4.2 Delete Remote Controller
The remote controller can’t control the main unit after it’s deleted.
In setup state, use keypad to input [21], then input the remote controller
number [1-8], and then press [#] to confirm. The main unit emits a long
beep and the [Signal] indicator flickers once. You will hear a voice
prompt “delete completed”.
Operating method: [21]
➩[A]➩[#]
A indicates: 1~8 remote controllers number.
6.5 Defense zone
6.5.1 Coding of defense zone
Wireless detectors have to be coded to the main unit in order to trigger it
alarms.
In setup state, use keypad to input [23], input the defense zone number you
want to code [01~99], and then input [#] to confirm. The main unit emits a
long beep and the corresponding defense zone is displayed on the screen.
You will hear a voice prompt “detector coding”. Then trigger a wireless
detector to emit a wireless signal; after receiving the signal, the main unit
makes a long beep, and you will hear “coding completed”, the [
]
indicator goes out at the same time.
Operating method: [23]
➩[XX]➩[#]
XX indicates: 01 ~99 defense zones number
LCD display: