User manual

Well SEC Electronic Co., Ltd Http://www.wellsecurityalarm.com
Page １４ of 35 Ver 2.1
6.2 Exit Settings
Press [*] and [#] buttons, the main unit emits a long beep and exits
settings. The [SET] indicator goes out and the system returns to disarm
state.
Operating method: 【*】
➩【#】
6.3
Factory Reset
In disarm status, use keypad to input [95175308246] and press [#] to
confirm, all the LED indicators will be on for 2 seconds and you will hear a
long beep. The main unit gets all its settings cleared and restores to its
factory settings successfully.
Operating method: [95175308246] + [#]
6.4 Remote controller
6.4.1 Coding of Remote Controller
The remote controller has to be code to the alarm host in order to
perform normally.
In setup state, use keypad to input [20], input the remote controller number
[1~8], and then press [#] to confirm. The main unit emits a long beep and
you will hear “remote control coding”. The [
] indicator is on without
flashing; press any button on the wireless remote controller, the main unit
makes a long beep and you will hear “coding completed”,[
] indicator
goes out, indicating the remote controller succeeds in coding.
Operating method: [20]
➩[A]➩[#]
A indicates: 1~8 remote controllers number. You can add maximum 8