Technical data

ManualsBrandsWELDING INDUSTRIES ManualsIndustrialMC101-0

SW209

Tips

Welding Tips

Heavy Duty “SW” Series

SW200 Series Oxy-Acetylene

The SW200 Series is for general and heavy welding and brazing. Swaged construction

provides greater heat concentration for improved “puddle” control.

Tips bent to 63-1/2° angle.

USE IN:

Torch Handles

- WH200 & SW1B.

FUEL GASES: These tips may also be used for brazing with Liquid Air Fuel-Gas or braz-

ing with propylene base fuel gases. When using these gases, select a tip two sizes larg-

er than recommended for the same work as acetylene.

Welding Range Pressure Each Gas Consumption Each

Tip Number Inches mm Drill Size (PSIG) at Reg. Gas (SCFH)

SW201 1/32 .7 71 10 2.3

SW203 5/64 1.9 67 10 3.2

SW205 1/8 3 57 10 6

SW207 3/16 5 54 10 12

SW209 3/8 10 49 10 23

SW210 1/2 13 44 15 36

Replaceable “O” rings: LW15 (Pkg. of 25).

Medium Duty “MW” Series

MW205

MW200 Series Oxy-Acetylene

MW200 Series is for general purpose medium duty welding which

features Smith “soft flame” for easier puddle control and better

penetration. Tips are bent to 63-1/2° angle.

Replaceable “O” rings: MW15 (Pkg. of 25).

USE IN:

Torch Handles

- WH100, MW5A & CW5A.

Welding Range Pressure Each Gas Consumption Each

Tip Number Inches mm Drill Size (PSIG) at Reg. Gas (SCFH)

MW201 1/32 .7 71 10 2.3

MW203 5/64 1.9 67 10 3.2

MW205 1/8 3 57 10 6

MW207 3/16 5 54 10 12

MW209 3/8 10 49 10 23

Consumption (SCFH: cubic feet per hour) figures shown, represent the average volumes of gases consumed when acetylene

is added until sooty smoke just disappears from the acetylene flame prior to opening the oxygen valve and adjusting to a

neutral flame.

FUEL GASES: These tips may also be used for brazing with Liquid Air Fuel-Gas or brazing with propylene base fuel gases.

When using these gases, select a tip two sizes larger than recommended for the same work as acetylene.

Consumption (SCFH: cubic feet per hour) figures shown, represent the average volumes of gases consumed when acetylene

is added until sooty smoke just disappears from the acetylene flame prior to opening the oxygen valve and adjusting to a

neutral flame.