Technical data

Tips
37
Cutting Tips
Heavy Duty “SC” Special Purpose / Acetylene
Tip Capacity Capacity Pressures - PSIG @ Reg. Consumption - SCFH Drill Size
Number Purpose (Inches) (mm) Oxygen Acetylene Oxygen Acetylene Cutting Preheat
SC13-3 Gouging
3
/
8
” wide x
1
/
4
” deep 10 wide x 6 deep 20 10 151 35 50-29 59
SC13-5 Gouging
1
/
2
” wide x
3
/
8
” deep 13 wide x 10 deep 25 10 246 50 39-10 55
SC14-3 Riser 1
1
/
2
” rivets 38mm rivets 35-40 10 190 20 51 56
SC15-2 Washing
1
/
2
” wide x
3
/
8
” deep 13 wide x 10 deep 30 10 336 40 3 57
SC17-0 Plate or Thin
3
/
8
” 10 20 10 55 4 62 62
Sheet Cutting
SC83 Heating 83,000 BTU’s N/A 15 10 58 52* NA 56
SC12-4X9 Cutting 4" 102 50 10 331 14 45 62
Gouging
SC13-3
Plate Cutting
SC17-0
Rivet/Riser Cutting
SC14-3
Rivet Blowing & Metal Washing
SC15-2
Gouging Tip SC13-3 & SC13-5
For edge preparation, removal of welds or gouging cracked metals.
Rivet/Riser Cutting - SC14-3
Cuts heads of bolts and rivets. It can also be used in 180° head cutting torch to
cut out boiler tubes. Works equally for cutting risers and bulk heads.
Rivet Blowing and Metal Washing - SC15-2
Quickly removes large quantities of metal. Heavy preheat primarily
used as a rivet blowing tip, but can be used for stud removal,
metal washing, gouging, veeing and groove cutting.
Plate Cutting - SC17-0
“Drag” style step tip cuts thin sheet metal with absolute minimum burn over and
plate warpage.
Heating - SC83
Delivers large volume of heat quickly for bending, straightening, shrinking,
forming and other heating applications. It allows heating with a one piece cutting
torch. (For use with hand cutting torches only, not recommended for use with
combination torch cutting attachments.)
Extra Long Cutting Tip - SC12-4X9
Tip for hard to reach areas. Size 4.
Extra Long Cutting Tip
SC12-4X9
Heating
SC83
* 2 cylinders required - based on 350 cu. ft. cylinder.
Tips This Page Use In: DG200 & SC200 Series Cutting Attachments (Except SC110 & SC83 Tips).
All SC & DG Series Hand Torches & Machine Torches.
9"