Instruction manual

19
How to set the protocol
1. Turn off the power
2. Set the Rotary Hexa Switch (0~F) to ‘ 0’. The Rotary Hexa Switch is located in
bottom side of the below picture.
3. Supply the power and then wait for around 3 sec -> It will be entered to
Protocol setting mode.
4. Turn the Rotary Hexa Switch (0~F) to any one of 1~6.
1: PELCO-D 2400BPS
2: PELCO-D 4800BPS
3: PELCO-D 9600BPS
4: D-MAX 2400BPS
5: D-MAX 4800BPS
6: D-MAX 9600BPS
5. Press down the mini joystick button (vertically). The mini joystick button is
located in upper side of the picture. (Menu key)
6. Turn off the power (Fished the selection of protocol)
7. Select Camera ID with Rotary Hexa Switch (0~F)
8. 1~E: Possible to be set for Camera ID.
☞ Caution ☜
0: Not allowed to be set – It is using for protocol setting ID. Not allowed to be set for
Camera ID
F : Not allowed to be set – It is using for Lock ID of automatic zoom/focus. Not allowed
to be set for Camera ID
9. Turn on the power and connect the communication line to check the operation.
* No need additional protocol setting once it is set.
6. Protocol Setting Manual