Instruction manual

You can specify Mask 1 and 2 simultaneously. The mask is used only for

determining the filter switch and any excessive bright area at night will be

masked.

※Note:

-If BACKLIGHT is set to BLC, the MASK AREA function will be deactivated.

◇ EXT

This enables an auto switch between DAY and NIGHT modes using the

interface with the external sensor. (For IR LED models, inside CDS sensor

will control IR LED ON/OFF.)

● WHITE BAL [DAY/NIGHT]

If you want to adjust the color scheme, use the WHITE BALANCE function.

◇ DAY in DAY mode, you can set the color values of RED and BLUE. The

screen will be displayed in colors according to your settings.

※Note:

-You can set the values of R-GAIN and B-GAIN only in AWC mode.

◇ NIGHT Use the NIGHT mode if you want to set the white balance

differently according to the ambient luminance. If the NIGHT mode is set to

OFF, the white balance will always operate as set in DAY mode; if not to

OFF, the camera will switch to as set in DAY/NIGHT mode according to the

brightness. In NIGHT mode, you can set the values of RED, BLUE and

BRIGHTNESS. The screen will be displayed in colors according to your

settings.

※ Note:

-You can set the values of R-GAIN and B-GAIN only in AWC mode. -If AGC

is set to OFF or FIX, you can not access the NIGHT menu.

For adjusting the white balance, the following 5 modes are provided:

◇ ATW1 (Auto Tracing White Balance mode 1): The camera can

automatically adjust the color temperature in real time, according to the

ambient conditions. The color temperature ranges from approx. 2500K to

9300K.