Product Manual
Table Of Contents
- Welch Allyn® Spot® Vision Screener Model VS100
- Introduction
- Controls, Display Window, and Connections
- Setting up the Vision Screener
- Vision Screener Operation
- Troubleshooting
- Cleaning the Vision Screener
- Specifications
- Warranty
Directions for Use Specifications 39
This product can be used with the following restriction(s):
France — Outdoor use is limited to 10 mW EIRP within the band 2454 to 2483.5 MHz.
Norway — Does not apply for the geographical area within a radius of 20 km from the
center of Ny-Ålesund.
General radio compliance
The wireless features of this device must be used in strict accordance with the
manufacturer’s instructions as described in the user documentation that comes with the
product. This device complies with Part 15 of the FCC rules, rules of the Canadian ICES-
003 and the essential requirements of the R&TTE Directive 1999/5/EC as described
below.
This device complies with EN62479, RSS-102 and 47 CFR 2.1093 for RF exposure
Industry Canada (IC) emissions
This device complies with RSS 210 of Industry Canada.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of this device.
L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes: (1) il ne doit
pas produire de brouillage et (2) l’ utilisateur du dispositif doit étre prêt à accepter tout
brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that
required for successful communication.
This device has been designed to operate with an antenna having a maximum gain of 2.0
dBi. Antenna having a higher gain is strictly prohibited per regulations of Industry Canada.
The required antenna impedance is 50 ohms.
Pour réduire le risque d'interférence avec d'autres utilisateurs, le type d'antenne et son
gain doivent être choisis afin que la puissance isotrope rayonnée équivalente (PIRE) ne
dépasse pas ce qui est nécessaire pour une communication réussie"
Ce dispositif a été conçu pour fonctionner avec une antenne ayant un gain maximal de 2.0
dBi. Antenne ayant un gain supérieur sont strictement interdites par la réglementation
d'Industrie Canada. L'impédance d'antenne requise est de 50 ohms.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conform à la norme NMB-003 du Canada.
Note
Effective Isotropic Radiated Power (EIRP).