Quick Reference Guide Instruction Manual

• Use the USB extension cable supplied

with the sensor to lessen chance of

USB connector damage

• Connect the pressure tubing to the

sensor and the other end of the

tubing to a flow transducer.

• Connect the USB sensor to a USB port on

your computer.

1 Install Software and USB Drivers

2 Connect USB Dongle to CPU

Each lot of flow transducers has a specific Calibration code.

Make sure to update these in the SW when you receive a

new lot of flow transducers.

The Lot number and Calibration Code are located on the

outside packaging label of the flow transducer box. Update

this information in the pre-calibration window or in the

Recording tab of the spiro settings.

3 Update Calibration Code

• This quick start guide is intended for use with CardioPerfect

orkstation Version 1.6.0 or higher.

• F

or complete directions for use and warnings, please

consult your user manual located on the SW CD.

SPIROPERFECT

QUICK START GUIDE