Specifications

3–10
Cordless Systems Manual
SOB (Start of Block) ] EOB (End of Block) ]
Data Character Selection
This selection selects the serial output data characters that may be sent from the
RS-232 device connected to the Auxiliary Port.
Default SOR Character = none (NUL: 00).
Default EOR Character = Carriage Return (CR: 0D).
Default SOB Character = none (NUL: 00).
Default EOB Character = End of Text (EOT: 04).
SOR (Start of Record) ] EOR (End of Record) ]
Enable
✱ Disable
Hardware Flow Control Selection
Note: The Auxiliary Port receive function will only work properly if RTS/CTS or
ACK/NAK flow control is used. If your host system does not support RTS/CTS
or ACK/NAK handshaking, some or all of your data will be lost.
This selection enables hardware flow control that checks for a CTS signal before
sending data. This option is useful when your application supports the CTS
signal.
] A two-digit number and Save are required after scanning this programming
bar code. Refer to the Programming Chart (inside back cover).