Specifications

Directions for Use Reference 93
Factory default settings
The monitor is shipped from the factory with these preset default settings. For
information about how to customize your monitor settings, see “Change Powerup Patient
Mode or store customized settings” on page 19.
Setting Factory default
Date
a
MO/DA/YR. This setting is automatically updated whenever it is changed during use
(continuously programmed).
Decimal
a
. (Period) This setting is automatically updated whenever it is changed during use
(continuously programmed).
HR/PR Sweep 25 mm/s
RR/BR Sweep 6.25 mm/s
Alarm Tone MEDIUM
HR/PR TONE LOW
HR/PR SOURCE ECG
RR/BR Source CO
2
if available or ECG (not programmable)
Patient Mode Adult
Display Brightness Normal
ECG Bandwidth Monitor
ECG Size 1 mV/cm
ECG1 Lead II
ECG2 Lead V
ECG Filter
a
60 Hz. This setting is automatically updated whenever it is changed during use.
ECG Pacer ON
RESP size 2X
RESP lead Ld2
RESP sweep 6.25 mm/s
RESP monitoring ON
RESP window ON
IBP Range 0 to 180 mmHg
IBP Rescale 0 to 140 mmHg (not programmable)
IBP Mode RESCALE
Invasive Pressure Formats Label dependent
NIBP Mode MANUAL
NIBP Auto Time 15 min
NIBP Smartcuf ON
SpO
2
SIZE 2x
SpO
2
C-LOCK OFF
SpO
2
Response NORMAL
TEMP F/C
a
Celsius
CO
2
Range 0 to 60 mmHg
CO
2
Sweep 6.25 mm/s
CO
2
Response NORMAL
CO
2
Units
a
mmHg
CO
2
Gas Compensation OFF
Sidestream CO
2
Flow Rate Adult: 90 ml/minute
Ped: 90 ml/minute
Neonate: 90 ml/minute
(The flow rate cannot be programmed to a different value in a Custom Patient Mode, see
“Change Powerup Patient Mode or store customized settings” on page 19.)
Display Wave Select Adult and Pediatric Patient Mode: ECG1, ECG2, P1, P2, and CO
2
= ON, and large NIBP
numerics are displayed (in order of priority); SpO
2
and RESP = OFF.
Neonatal Mode: all waveforms are ON and large NIBP numerics are displayed (in order of
priority).
Trend Group NIBP
Alarm Limits All are ON except P2
HR/PR Alarm Limits
a
CAN TURN OFF