Specifications

Directions for Use Alarms & Alerts 63
Printer alert messages
CHECK DOOR. The door on the bottom of the printer is open. Close the door to
remove this message.
LOW BATTERY, PRINTER DISABLED. The monitor’s battery voltage is too low to
support printing. Connect the ac power adapter to recharge the battery (see “Connect
the AC power adapter to recharge the battery” on page 81).
OVERHEATING. The printer is overheating. Service may be required.
PAPER OUT. To add printer paper, see “Install printer paper” on page 85.
Defibrillator alert message
DEFIB FAULT, CHECK INTERFACE CABLE. The monitor detects a problem with the
interface cable. Check the cable and defibrillator.
Very low battery alert message
VERY LOW BATTERY, PLUG IN EXTERNAL POWER ADAPTER. The monitor battery
needs to be recharged. Connect the ac power adapter to recharge the battery
(“Connect the AC power adapter to recharge the battery” on page 81).
If the battery is not recharged, the monitor will begin to disable monitor functions and
eventually turn off completely.
Troubleshooting system error messages
If the monitor detects a system error, it will display a message similar to the following:
ERROR NUMBER: 1-123-4567
REMOVE CUFF FROM PATIENT
PLEASE NOTIFY YOUR LOCAL SERVICE
REPRESENTATIVE OR WELCH ALLYN PROTOCOL, INC.
This type of message indicates that the monitor detected an internal system problem
which may require service for the monitor. If the monitor displays this message,
disconnect the monitor from the patient. Write down the error number for the service
department, and send the monitor to your facility’s biomedical engineering department.
Note
The message REMOVE CUFF FROM PATIENT as shown above does not imply
that the detected error is related to NIBP. It is simply a reminder to disconnect the
NIBP cuff from the patient if a cuff is connected.