User's Manual Part 9

Directions for Use Monitor Configuration 113
About Temporary Configuration
While monitoring a patient, you can use the monitor buttons to temporarily adjust many of
the monitor settings to accommodate the needs of a specific patient. These custom
settings persist through a power cycle if you select to save patient data on shut-down.
The persist until they are changed manually or by Acuity, or until the monitor is powered
down and then powered up to monitor another patient.
To learn which parameters can be temporarily defined using the User Interface, see the
“Parameter Configuration Matrix” on page 113.
About Acuity-Defined Configuration
When the monitor comes into communication with the Acuity Central Station, Acuity
downloads some parameter values to the monitor.
The Acuity-defined configuration persists until the monitor is powered off.
To learn which parameters are defined by Acuity, see “Parameter Configuration Matrix”
on page 113.
Parameter Configuration Matrix
This table lists shows the factory settings and the possible values for all parameters, and
indicates which parameters and settings can be defined by Acuity, through the
Configuration Utility, or by the clinician through the monitor buttons.
Note
This table shows only those parameters that can be changed.
Note
Except for Radio ESSID (NetName) and Can Disable HR/PR Alarm Limits, this
table does not show parameters intended for use only by qualified service
personnel.