User's Manual Part 9

130 PC Utility Welch Allyn Propaq LT Vital Signs Monitor
Modifying a Configuration File
To change a configuration file that has already been completed, follow these steps:
1. Start the utility.
2. Select the configuration file that you want to modify.
3. Click Edit.
4. Using the section tabs, navigate to the setting you want to change.
5. Enter the new value.
6. Repeat steps 4 and 5 until you have updated all of the settings you want to change.
7. Click Save or Save/Close.
Configuring a Monitor
1. Seat the monitor in the cradle.
2. If the monitor is off, turn it on and select Start New Patient.
3. Start the utility.
4. Select the configuration file that you want to upload.
5. Click Load.
6. Wait a few seconds. When the upload is complete, a completion message appears
and then the monitor shuts off.
7. Remove the monitor from the cradle. It is now configured.
About the Configuration Display
Figure 113. Configuration Display
Configuration
commands
Windows command menus
Page tabs
Configuration settings
and parameters