User's Manual Part 6

ManualsBrandsWelch Allyn ManualsElectronicsPropaq 802 LTRN

Table Of Contents

Monitoring in Communication with Acuity

Directions for Use Monitoring in Communication with Acuity 83

To Disconnect From the Network

1. Highlight and press .

2. Highlight Disconnect (Figure 82), press , and confirm.

Figure 82. Wireless Mode: Disconnect

changes to and the message ‘DISCONNECTED’ appears (Figure 83), alternating

with the patient ID number.

Figure 83. Patient Disconnected from the Network

To Reconnect a Patient to the Network

1. Highlight and press .

2. Highlight Reconnect and press .

The monitor prompts you for information about the connection and the patient.

3. Provide the information requested.

Note

Disconnecting the monitor from the network while the monitor is outside of

network range greatly extends battery life. However, connection with the network

must first have been established before this is possible.

Note

If you disconnect from the network and then turn off the monitor before

reconnecting, and if you then select Continue Patient when you again turn on

the monitor, the monitor powers up in the disconnected state.

STEWART, ANN

7762940

15:20:28

Adult

Rm ED 263

HR/min

NIBP mmHg

Resp/min

SpO2

II 1mV/cm

Wireless Mode

Exit

Disconnect

Acuity Menu

Wireless Drop-Down Menu