User's Manual Part 4
42 Overview of Monitor Operation Welch Allyn Propaq LT Vital Signs Monitor
Figure 33. Demo Mode: Initial Display
When you enter Demo mode, the monitor is in ‘Demo Mode Low’. The simulated vital
signs of the patient are steady and do not cause any alarms at the default alarm limit
settings. You can explore the monitor displays and menus, and you can change the same
settings and values in Demo mode that you can change in normal mode.
In Demo Mode Low, if you adjust the alarm limits to put the simulated patient’s vital signs
out of limits, the monitor simulates an alarm condition. Another way to simulate an alarm
condition is to switch the monitor to Demo Mode High, which uses higher numeric
values.
To Switch to Demo Mode High
1. Access the Setup menu. (“To Access the Setup Menus” on page 38.)
2. Press to highlight Timings (Figure 34).
Figure 34. Setup: Timings
80
80
97
97
12
12
ID: 01018VDO9PBH
ID: 01018VDO9PBH
3:00:06P
3:00:06P
Adult
Adult
Rm 239
Rm 239
NIBP mmHg
NIBP mmHg
Resp/min
Resp/min
HR/min
HR/min
SpO2
SpO2
%
SIMULATION
SIMULATION
S D M
10
10
15
15
30
30
On
On
Off
Off
II 1mV/cm
II 1mV/cm
Exit
Exit
Trends
Trends
Snapshots
Snapshots
Setup
Setup
80
80
HR/min
HR/min
NIBP mmHg
NIBP mmHg
Resp/min
Resp/min
SpO2
SpO2
Demo Mode
Demo Mode
Backlight Timeout (min)
Backlight Timeout (min)
Setup
Setup
12
12
97
97
%
ID: 01018VDO9PBH
ID: 01018VDO9PBH
3:00:06P
3:00:06P
Adult
Adult
Rm 239
Rm 239
Alarms
Alarms
ECG
ECG
NIBP
NIBP
Timings
Timings
Service
Service
Display Timeout (min)
Display Timeout (min) 2
Low
Low
5
10
10
15
15
30
30
On
On
Off
Off2 5
SIMULATION
SIMULATION
High
High
Timings
Default Demo mode (Low)