User's Manual Part 3

Table Of Contents

Directions for Use Overview of Monitor Operation 15

Selecting a Language

To change the language of the monitor interface:

1. If the monitor power is on, press to turn it off.

2. Press to turn the monitor power on.

3. Immediately after pressing , and before any screen appears, simultaneously press

the up arrow and down arrow buttons ( and ). Keep the buttons pressed until

the language selection screen appears (Figure 8).

Figure 8. Language Selection Screen

4. Use the arrow buttons ( , , , and ) to highlight the language you wish to use.

5. Press .

The monitor powers down and then powers up in the selected language.

The monitor will always power up in this language until the setting is changed again. You

can change the setting again only by one of the following:

• Performing this procedure again.

• Downloading a new configuration to the monitor. (See “Configuring the Monitor”

on page 126).

•Acuity.

Note

If you select French, HR/PR alarm limits cannot be turned off unless you go

through the service menus to change this setting. If you do change this setting,

the change stays in effect through power cycles.

For information about using the service menus, refer to the Propaq LT Monitor

Service Manual (810-1811-XX).

English

Deutsch

Franç.

Español

Ital.

Polski

Nederl

Svenska

Português