User Manual Part 5

54 Standalone Monitoring Welch Allyn Propaq LT Vital Signs Monitor
Continuing to Monitor a Patient on Power-Up
If a patient’s data was saved before the monitor was last turned off (see “To Turn Off the
Monitor” on page 45), you can resume monitoring that patient when the monitor is turned
on again. (When patient data is saved, the monitor settings are also saved.)
To resume monitoring the same patient:
1. Turn on the monitor. The “patient data stored” screen appears (Figure 52):
Figure 52. Start-Up with Saved Data
2. Verify that the displayed name and ID match that of the current patient.
3. Highlight Continue Patient (Figure 53) and press .
Figure 53. Start-Up with Saved Data
Select ( ) to delete data
Select ( ) to delete data
and start a new patient.
and start a new patient.
Portland Westside Hospital
Portland Westside Hospital
Emergency Department
Emergency Department
Note!
Note!
There is patient data stored for
There is patient data stored for
Hall, Robert E. ID: 3456187
Hall, Robert E. ID: 3456187
Start New Patient
Start New Patient
Continue Patient
Continue Patient
Info
Info
Demo
Demo
Select ( ) to continue
Select ( ) to continue
monitoring this patient.
monitoring this patient.
Portland Westside Hospital
Portland Westside Hospital
Emergency Department
Emergency Department
Note!
Note!
There is patient data stored for
There is patient data stored for
Hall, Robert E. ID: 3456187
Hall, Robert E. ID: 3456187
Start New Patient
Start New Patient
Continue Patient
Continue Patient
Info
Info
Demo
Demo