User Manual Part 5

Directions for Use Standalone Monitoring 75
To Discontinue Monitoring
1. Press . The Power Off screen appears (Figure 74 on page 75).
Figure 74. Power Off
• If you intend to continue monitoring the same patient when the monitor is turned
on again, and if you want to save the stored vital-signs data and monitor settings
(to print them at a PC), highlight Save & Shut Down and then press . The
monitor saves the patient data and the monitor settings, and then turns off.
• If you do not intend to continue monitoring the same patient when the monitor is
turned on again, highlight Delete & Shut Down and then press . The monitor
turns off without saving the data and the settings.
2. Disconnect the leads and sensors from the patient.
If you press and then decide that instead of turning off the monitor you want to resume
monitoring the same patient, do one of the following:
• Highlight Cancel and press .
• Wait for 30 seconds.
• Press .
Note
When you power down from Demo mode, you cannot save settings and patient
data. In this case, the following screen appears:
Select ( ) to delete patient data
Select ( ) to delete patient data
You have pressed the Power Off button.
You have pressed the Power Off button.
Delete & Shut Down
Delete & Shut Down
Cancel
Cancel
Setu
pSetup
and shut down.
and shut down.
15:01:24
15:01:24
Adult
Adult
Rm 239
Rm 239
There is patient data stored for
There is patient data stored for
Hall, Robert E. ID: 3456187
Hall, Robert E. ID: 3456187
Save & Shut Down
Save & Shut Down
HALL, ROBERT E.
HALL, ROBERT E.
3456187
3456187
Delete & Shut Down
Delete & Shut Down
Cancel
Cancel
Setup
Setup
ID: SET_DEMMATJP
ID: SET_DEMMATJP
12:41:32
12:41:32
Adult
Adult
Rm
Rm
Select ( ) to delete patient data
Select ( ) to delete patient data
and shut down.
and shut down.
You have pressed the Power Off button.
You have pressed the Power Off button.
SIMULATION
SIMULATION