Product Manual

SECTION 2

Important note regarding WAM connectivity

A version 1 WAM must be used with a version 1 UTK, and a version 2 WAM must be used with a version 2 UTK. If

the version of WAM does not match the version of UTK that is within the ELI electrocardiograph, the WAM will

not pair to the electrocardiograph and a “SEARCHING FOR WAM” message will continue to be displayed. When

using the WAM, it must be successfully paired to the electrocardiograph before operation.

Using the WAM Acquisition Module

ECG acquisition and rhythm strip printing can be performed at the WAM acquisition module in addition to the

ELI electrocardiograph. To use the WAM, refer to the WAM user manual.

NOTE: The device must be configured at the factory for use with the WAM. Select

F6 (More)

followed by

F6 (More)

to determine the device’s setting. “WAM Option Not Available” will display if the

device is not configured to work with the WAM.

NOTE: WAM must be paired to electrocardiograph before operation.

Using the AM12 Acquisition Module

ECG acquisition and rhythm strip printing can be performed at the AM12 acquisition module after the patient is

connected in addition to the ELI electrocardiograph. Refer to Record an ECG section to prepare the patient.

1. Press to acquire 12-lead ECG.

2. Press for continuous rhythm print; press again to stop printing.

The LED indicates status of the connected leads:

• Not lit = Electrocardiograph is powered off or AM12 is not connected.

• Green light = Power is on and all leads are connected.

• Yellow light = Lead fail.

Installing the WLAN Antenna

The device with optional WLAN module is shipped with the antenna not installed: the antenna can be found in the

accessory box.

1. Remove the antenna from the accessory box.

2. Locate the antenna connector on the back of the device.

3. Mount the antenna on the connector by rotating the antenna clockwise. The antenna must be finger tight

to its connector.

4. Locate the built-in hinge and fold the antenna (it will now be at a 90° angle); continue to rotate the

antenna clockwise until it is placed vertically. This will guarantee the best signal for the WLAN module.

NOTE: For more information about the use of the WLAN option, refer to Appendix A.