Product Manual
14
SECTION 2
Loading Paper
Figure 2-2
1. Remove all packaging including cardboard backing from the paper stack.
2. Facing the front of the device, use the release latch on the left side and slide the paper tray cover to the left.
3. Place the stack of thermal paper into the paper tray such that the grid side of the paper is up when it is pulled
over the paper tray cover. The paper cue mark (a small black rectangle) should be in the lower left corner.
4. Manually advance one page of paper beyond the closure point of the writer. Make sure the paper lays on the
black roller evenly within the channel of the paper door. If paper is not manually advanced evenly, risk of
jamming or queue faults increases.
5. Slide paper tray cover to the right until the cover latches in a locked position. You will hear a sharp click when
the door is properly latched.
WARNING: Risk of injury to fingers in writer paper door or platen drive mechanisms.
NOTE: For proper printing performance, be certain to use Mortara recommended thermal paper.