Product Manual
Table Of Contents
- 1. Getting started
- 2. Recording an exercise ECG
- 2.1 The Real-time monitor
- 2.2 Record an exercise ECG
- 2.3 Real-time monitor
- 2.3.1. Select how you want to view leads
- 2.3.2. Measure blood pressure
- 2.3.3. Capture an event
- 2.3.4. Patient Perception Parameters
- 2.3.5. Duke Treadmill Score
- 2.3.6. Add a comment
- 2.3.7. Apply filters
- 2.3.8. Manual load change
- 2.3.9. Pacemaker pulse detection
- 2.3.10. Signal quality indication
- 2.3.11. Printing during recording
- 2.3.12. Target heart rate
- 2.3.13. Target Workload
- 3. Viewing an exercise ECG
- 3.1 About viewing exercise ECGs
- 3.2 View an exercise ECG
- 3.3 Work with the Summary view
- 3.4 Work with the Averages view
- 3.5 Work with the Full disclosure view
- 3.6 Work with the 2x6 and 4x3 view
- 3.7 Work with the Trends view
- 3.8 Work with the ST table view
- 3.9 Work with the Heart rate view
- 3.10 Work with the ST/HR view
- 4. Interpreting an exercise ECG
- 5. Printing an exercise ECG
- 6. Maintaining the recorder
- 7. Customizing the Exercise ECG module
- 8. Customize exercise protocols
- 9. Troubleshooting
- 10. Before installing the Exercise ECG software
- 11. Installing the Exercise ECG Module
- 12. Safety and precautions
- 13. Guidance and Manufacturer’s Declarations
- 14. Function keys
- 15. Additional information
CardioPerfect Workstation
Exercise ECG Module - User Manual
Analog
TTL
DIR 80012335 Ver. D 68 / 83
Not
e
: Cables which connect to the Pro Link must be terminated in a mini-phone, 3.5 mm,
stereo plug. The interfacing cables must follow the connection convention summarized by the
following pin assignment diagram:
No Connection
Signal (+)
Re
ference (-)
Connector pin assignment
The TTL and
Analog connections are not intended to be used with
audio/IT equipment.
Caution
11.4 Install the PCI CPCOM card (MD recorder only)
When you want to use a PCI CPCOM card you need to have a free PCI slot on your
computer. The installation of the PCI CPCOM card is relatively easy and can be done by
following the instructions below:
1. Open the computer.
2. Insert the PCI CPCOM Card in an empty PCI slot and close the computer.
3. Start the computer. The system will ask you for a driver when logging on to the
computer for the first time after you installed the card.
Install the driver by running the setup program that is located on
the Workstation CD, in the directory:
For
Windows:
R:\Drivers\
CPCOM-PCI\Win2000\
2000 / XP
For "R" substitute the drive letter of your CD_ROM drive.
4. Restart the computer.