Product Manual
Table Of Contents
- 1. Getting started
- 2. Recording an exercise ECG
- 2.1 The Real-time monitor
- 2.2 Record an exercise ECG
- 2.3 Real-time monitor
- 2.3.1. Select how you want to view leads
- 2.3.2. Measure blood pressure
- 2.3.3. Capture an event
- 2.3.4. Patient Perception Parameters
- 2.3.5. Duke Treadmill Score
- 2.3.6. Add a comment
- 2.3.7. Apply filters
- 2.3.8. Manual load change
- 2.3.9. Pacemaker pulse detection
- 2.3.10. Signal quality indication
- 2.3.11. Printing during recording
- 2.3.12. Target heart rate
- 2.3.13. Target Workload
- 3. Viewing an exercise ECG
- 3.1 About viewing exercise ECGs
- 3.2 View an exercise ECG
- 3.3 Work with the Summary view
- 3.4 Work with the Averages view
- 3.5 Work with the Full disclosure view
- 3.6 Work with the 2x6 and 4x3 view
- 3.7 Work with the Trends view
- 3.8 Work with the ST table view
- 3.9 Work with the Heart rate view
- 3.10 Work with the ST/HR view
- 4. Interpreting an exercise ECG
- 5. Printing an exercise ECG
- 6. Maintaining the recorder
- 7. Customizing the Exercise ECG module
- 8. Customize exercise protocols
- 9. Troubleshooting
- 10. Before installing the Exercise ECG software
- 11. Installing the Exercise ECG Module
- 12. Safety and precautions
- 13. Guidance and Manufacturer’s Declarations
- 14. Function keys
- 15. Additional information
CardioPerfect Workstation
Exercise ECG Module - User Manual
DIR 80012335 Ver. D 53 / 83
7.5 Exercise ECG-settings -Devices tab
Use the Devices tab to select and configure the exercise devices.
Important: In order to make changes in this section, you must have Windows
Administration privileges. These privileges are set outside of CardioPerfect
application, and are specific to each computer.
If a section is grayed out, you do not have the necessary privileges, and should consult your
IT administrator.
The Devices tab contains the following options:
Exercise device
Type
The type of exercise device that is used during the exercise
ECG.
Device
Select your exercise device from the pull-down list, if your
exercise device is not in the list or if you do not want your
device to be controlled by the CardioPerfect workstation, then
select “manual”
Connected to
From this list, you can select the COM-port to which the
exercise device is connected. This is only possible when the
selected device has a serial (or RS232) interface.
Default protocol
The default workload protocol that is used for the exercise
ECG.
Instant manual
load changes
When this option is enabled the treadmill speed and elevation
or the ergometer workload will be instantly adjustable in the
Real-time monitor.
Blood pressure device
Device
With this option you can specify which blood pressure device
is used for measuring the patient's blood pressure during the
exercise test.
Connected to
From this list you can select the COM-port to which the blood
pressure device is connected.
Default protocol
With this option, you can specify which protocol is used by
default for measuring the blood pressure during the test.
Select Manually controlled if the blood pressure protocol will
not be used or if the protocol is selected at the start of a test.