Product Manual
Table Of Contents
- 1. Getting started
- 2. Recording an exercise ECG
- 2.1 The Real-time monitor
- 2.2 Record an exercise ECG
- 2.3 Real-time monitor
- 2.3.1. Select how you want to view leads
- 2.3.2. Measure blood pressure
- 2.3.3. Capture an event
- 2.3.4. Patient Perception Parameters
- 2.3.5. Duke Treadmill Score
- 2.3.6. Add a comment
- 2.3.7. Apply filters
- 2.3.8. Manual load change
- 2.3.9. Pacemaker pulse detection
- 2.3.10. Signal quality indication
- 2.3.11. Printing during recording
- 2.3.12. Target heart rate
- 2.3.13. Target Workload
- 3. Viewing an exercise ECG
- 3.1 About viewing exercise ECGs
- 3.2 View an exercise ECG
- 3.3 Work with the Summary view
- 3.4 Work with the Averages view
- 3.5 Work with the Full disclosure view
- 3.6 Work with the 2x6 and 4x3 view
- 3.7 Work with the Trends view
- 3.8 Work with the ST table view
- 3.9 Work with the Heart rate view
- 3.10 Work with the ST/HR view
- 4. Interpreting an exercise ECG
- 5. Printing an exercise ECG
- 6. Maintaining the recorder
- 7. Customizing the Exercise ECG module
- 8. Customize exercise protocols
- 9. Troubleshooting
- 10. Before installing the Exercise ECG software
- 11. Installing the Exercise ECG Module
- 12. Safety and precautions
- 13. Guidance and Manufacturer’s Declarations
- 14. Function keys
- 15. Additional information
CardioPerfect Workstation
Exercise ECG Module - User Manual
2. Recording an exercise ECG
2.1 The Real-time monitor
The Real-time monitor is displayed when you start a new exercise ECG. During the test, this
window allows you to control and monitor all aspects of the test, and review any recorded
results.
Button bar
Tabs
Overview area
ECG traces
Tabs
ECG tr
aces
The lead
s of the ECG. You can select different lead configurations
(1x12, 2x6, 4x3) from the shortcut menu. With the shortcut menu
you can also adjust the chart speed and the sensitivity.
Dividers
The dividers in the ECG traces area can be switched on or off from
the shortcut menu.
Average complexes
The area to the right of the ECG traces displays the average
complexes.
Options available form the shortcut menu:
Marker option on or off. If the Markers option is enabled the
ST measurements are displayed next to the Average
complex.
The Slope option displays the Slope value next to the
Average complex if the Markers option is enabled.
The reference complex can be displayed on top of the
Average complex.
The current complex can be set as reference.
Note: If square waves are displayed the signal on one or more of the channels is erroneous
see section 2.3.10 on page 25 for more information.
DIR 80012335 Ver. D 10 / 83