Quick Reference Card - Quick Reference Guide User Manual

Add a patient to the patient list

(not connected to central station)

1. TouchthePatientstab.

2. TouchAdd.

3. Touch

andthenenterpatientinformation.

4. Touch

tocyclethroughthepatientdataelds.

Note YoucanuseabarcodescannertoenterapatientIDinthePatientID

   eld.Touch

inthePatientIDeld,scanthebarcode,and

   touchOK.

5. TouchOKtoreturntotheHometab.

Conﬁgure parameter options

1. TouchtheSettingstab.

2. TouchtheSetuptab.

3. Touchtheparameter(s)intheverticaltabyouwanttomodify.

 (Touchthe toscrollthroughthelistasneeded.)

4. Modifysettingsand/ormodiersforeachparameterasdesired.

 Thenewsettingstakeeffectimmediately.

Clean the monitor or stand

1. Powerdownthemonitor.

2. Wipetheequipmentwithoneofthefollowing:

 •CaviWipes

™

 •Sani-Cloth

Plus

 •clothdampenedwith70percentisopropylalcohol

 •clothdampenedwith10percentchlorinebleachsolution

  (rinseoffbleachwithadampcloth)

3. Allowtheequipmenttodryfor10minutesbeforeuse.

104703