Product Manual

The Clinician ID appears in the Clinician ID field on this tab and in the Status area on

the Home tab.

Use a barcode scanner

The monitor enables the scanning of patient and clinician barcodes to enter ID

information. The barcode scanner (scanner) supports linear and two-dimensional

barcodes.

If you have not done so previously, use the instructions provided with the scanner to

attach the scanner to the monitor.

Note Refer to the manufacturer's instructions to ensure that the scanner is set

to USB Com Emulation mode. Confirm the type of EMR version being used

by your facility.

1. Remove the scanner from its holder.

2. Hold the scanner approximately 6 inches (15.4 cm) from the barcode and squeeze

the scanner trigger so that the light from the scanner appears on the barcode.

Once the scanner completes a successful barcode reading, the ID appears in the

targeted area (Patient frame, data field, or Device Status area). See the additional

notes below.

If the scanner has difficulty reading the barcode, slowly adjust the distance and the

angle between the scanner and the barcode while squeezing the scanner trigger. If it

continues to have difficulty, verify that the barcode is as flat as possible.

Note You can scan a patient's barcode from the Home tab. The scanned ID

appears in the Patient frame on the Home tab.

Note Scanning a clinician ID while the Clinician ID pane is open places the

scanned ID into the Clinician ID section of the Device Status area. Touch

OK to return to the Home tab and to begin obtaining patient

measurements.

Profiles

The monitor offers multiple profiles, including Spot, Office, and Intervals.

Spot profile

The Spot profile is optimized for rapid multi-patient vitals capture with custom and

additional parameters, facility-specific login format, vital sign capture, and multiple

patient review.

The Spot profile Home tab displays the following parameters and features:

•

NIBP

• Pulse rate

• Respiration rate

• Temperature

• SpO2

• Custom scores

• Additional parameters

Directions for use Startup 31