Product Manual

4 Fiber Optic Laryngoscope Blades and Handles Welch Allyn
Lamp Cartridge
Lamp cartridge can be wiped with cloth dampened with 70% isopropyl alcohol. DO NOT
ALLOW SOLUTION TO ENTER INTO CARTRIDGE.
The lamp cartridge CANNOT be SOAKED OR AUTOCLAVED.
May be ethylene oxide sterilized (see above). Lamp should be left in.
Repair/Maintenance
Battery Replacement
See figure 4
1. Unscrew bottom cap and remove batteries. Stubby handles: pull on tab to remove
battery pack. Remove batteries by pulling one end away from pack.
2. Alkaline batteries have been supplied with your handle for maximum performance
(nickel-cadmium with rechargeable handle) and are recommended as replacements.
Ordinary carbon-zinc batteries may also be used.
3. Replace with appropriate size batteries and replace bottom cap. Stubby handles:
insert battery pack with tab side down.
Instructions for Recycling Nickel-Cadmium Batteries
Welch Allyn employs the services of an agency which can disassemble and recycle all
components of nickel-cadmium batteries so that nothing gets land-filled or incinerated. If
you wish to dispose of your expended Welch Allyn rechargeable battery via recycling (in
the US / Canada only), please send to:
For locations outside the U.S. and Canada consult your local recycling authority for correct
disposal of batteries.
Lamp Replacement
See figure 5.
1. Unscrew bottom cap counterclockwise and remove batteries. Lamp holder cartridge
assembly will remain in main handle. Prior to removal, allow lamp time to cool.
Remove by applying finger pressure in the direction shown by the arrow.
2. Remove outer shroud from holder by rotating shroud counterclockwise.
3. Next, remove lamp by rotating counterclockwise.
4. Replace lamp with Welch Allyn lamp #06000 (Specification: 2.5V, 2W, Halogen HPX)
or #00300 (Specification 3.5V, 2.7W, Halogen HPX) per reference chart.
Welch Allyn
RECYCLE BATTERY
4341 State Street Road
Skaneateles Falls, NY 13153-0220
Welch Allyn Canada
RECYCLE BATTERY
160 Matheson Blvd. E
Mississauga, Ontario CANADA L4Z 1V4
Caution Be sure lamp’s glass envelope is clean and free of any fingerprints after
assembly. If necessary, the glass may be cleaned with a soft cloth or cotton ball
moistened in alcohol.