Product Manual

CAUTION Do not use a long press of to power down the monitor
when it is functioning normally. You will lose patient data and configuration
settings.
Set the date and time
1. Touch the Settings tab.
2. Touch the Device tab.
3. Touch the Date/Time vertical tab.
4. To change the date and time values: Touch the up and down arrow keys or touch
and enter a value.
Repeat for each value you want to change.
Note The date and time stamps on saved patient measurements
will adjust in response to new date and time settings.
Enter clinician information
1. Go to the Clinician tab using one of these methods:
• On the Home tab, touch the Clinician ID section of the Device Status area (top
left corner of the screen).
• Touch the Settings > Clinician tab.
2. To enter the clinician name, touch , located at the right of the text field, and
enter characters.
You can enter up to 32 characters for the clinician's first and last name. Enter only 1
character for the middle initial.
3. To enter the clinician ID, use one of these methods:
• Touch and enter the ID.
• Scan the clinician's barcode with a barcode scanner. The scanned ID appears in
the field.
4. If prompted, enter your system password in the Authentication pane.
5. Touch OK to save your entries and return to the Home tab.
Set the default configuration
1. Enter or adjust the settings you want to add or change on the device.
Note The new settings appear as they are completed but are
temporary until they are saved.
2. Touch the Settings tab.
3. Touch the Device tab.
4. Touch the Defaults vertical tab.
5. Touch Save as default.
34 Startup Welch Allyn Connex
®
Vital Signs Monitor 6000 Series™